Installation Guide | Nelsmann Japanese Toilet
Install your Nelsmann Smart Toilet
This installation guide walks you through installing your Nelsmann Smart Toilet step by step. A simple installation in just a few steps.
~2 hours
A one-time installation.
No specific expertise
The steps are simple and explained step by step.
Connection kit included
Everything you need is included in the package.
Instructions + 7-day-a-week support
Clear instructions, and our team is available at any time.
Before you start: what you need
Take two minutes to check these three points. Once the package is open and the space is cleared, installation is quick.
Included in the package
- The Nelsmann toilet
- The remote control and its holder (battery included)
- The backup battery pack
- The installation manual
To be planned at your end
- A grounded 220-240V electrical outlet near the toilet
- An accessible water supply, with a suitable shut-off valve and connection hose
- A suitable waste outlet (floor-level for floor-standing models, wall-level for wall-hung models)
Tools to plan for
- A wrench (for the water connections)
- A screwdriver
- Silicone sealant (for final installation)
Installation steps
Follow them in order, without rushing. Each step is explained simply.
Prepare the water supply
Turn off the main water supply to your home: this prevents any leaks during installation. Check that your existing shut-off valve is functional, then clean and dry the floor where the toilet will be installed.
Locate the position
Measure the base of the toilet and mark the floor: the center of the waste pipe and the front centerline of the fixture. These marks will allow you to position the toilet perfectly aligned with the waste pipe on the first try.
Install the seal
Place the O-ring at the toilet's waste outlet, making sure it is tight and properly positioned. It ensures a watertight seal between the toilet and the waste pipe.
Install the toilet
Align the device with your guides, then slowly lower it to match the marks. Next, press down firmly so that the seal conforms well to the floor.
Connect the water
Connect your water supply hose to the shut-off valve and tighten. Turn the valve back on and check for leaks. If a drip appears, retighten or reposition the affected part.
Connect the electricity
Connect the appliance to a grounded 220V outlet. Check that the indicator light turns on: this means the appliance is properly powered.
Check that everything is working correctly
Test the flush, washing, drying, and remote control one by one. Does everything respond correctly? The essentials are covered.
Final fixation
Once everything is approved, apply a bead of silicone sealant all around the contact area between the base of the toilet and the floor, for a clean and stable finish.
